Click here for a printable PDF of this card
Measurements:
- Smoky Slate: 5-1/2” x 8-1/2” scored at 4-1/4”, folded then burnished with the Bone Folder
- Night of Navy: 3-3/4” x 5”
- Designer Series Paper: 3-1/2”x 4-3/4”
- Basic White: 4”x 2-1/2”, 3-1/2” x 1-1/2” (4), 2-1/2” x ½”
Instructions:
- Glue DSP to Night of Navy panel.
- Stamp airplane on largest Basic White cardstock and color in with Stampin’ Blends. Die cut airplane and set aside.
- Stamp sentiment with Night of Navy on Basic White strip then die cut. Using Paper Snips, trim triangle end so whole banner is about 2-1/4” long.
- Die cut tiny piece that will hold edge of banner with Night of Navy cardstock. Use glue to attach it to the right edge of the sentiment banner.
- Die cut 4 clouds so the long straighter edge is off the cardstock. You want a straight edge on all four. Once die cut, tape two together, from back side, so straight edges meet. Repeat to create second cloud.
- Glue airplane to one cloud so the wings cover the seam between the two cloud halves.
- Glue remaining cloud at an angle and towards right in a position so the bottom edge of wing will cover it when second goes on top of it.
- With dots of glue, attach banner piece to back of airplane.
 |  |  | |
 | |||
 |
